Raximo handlebar tapered -MX ideal for Enduro, Motocross and Adventure Bikes for model: KTM Supermoto SMC 660 2005
This handlebar was developed specifically for motocross and enduro or adventure bikes, the handlebar is made of a high-strength Ergal aluminum alloy 7075 T6, a bending of the handlebar after a fall or a fall as bein a "normal" aluminum handlebar is largely impossible.
The high torsional stiffness is also achieved by 5mm material thickness. For a high torsion resistance of the handle, the left side of the handlebar is ribbed.
Included in the ABE are models where we and the TÜV have tested not only the material and the design of the handlebar itself, but also the cable lengths and trains with the new handlebar. With original parts here is a Verbau security. Handlebars that meet this requirement with ABE are displayed after the vehicle selection and above the shopping cart button with a green field (mode-specific article).
The handlebar is also available as a universal handlebar but must then be approved and registered by the TÜV. If the new handlebar extends the path or angles change, it may be that the cables or lines are too short and must be retrofitted from the accessories trade.
A preliminary check can be made before ordering. This is done by measuring the distance between the center of the handlebar and the right handlebar edge. If this diagonal dimension does not deviate significantly from our handlebar dimension, it is very likely that the cables and lines do not change much. However, despite everything, you must always pay attention to the instructions in the mounting instructions also in relation to the radii of the brake lines.
Technical details:
high-strength tubular aluminum handlebar RAXIMO MX
28.6 mm Ø in the clamping area and 22mm outside (butted)
perfect adjustability through laser engraved scaling
Dimensions:
Width: 800mm
height : 120mm
offset to the rear : 75mm
outer diameter in the area of the clamp: 28,6mm
Outer diameter in the area of the grips: 22mm
Inner diameter: approx. 12,5mm
Handlebars are delivered with an ABE (General Operating Permit), an entry in the vehicle documents is not required if the model is listed in the vehicle list of the ABE.
If your vehicle is not listed in the ABE, you can have the mounting of the handlebars in accordance with §19.2 StVZO approved by your competent TÜV test center and registered in the vehicle documents.
Scope of delivery:
1 x Raximo handlebar "MX"
1 x TÜV
