Raximo handlebar "Flat Drag Bar" conical 28,6mm with TÜV
for Model: Ducati Monster 937+ 1M 2021
The extra flat Drag Bar handlebar from Raximo is perfect for conversions for choppers, cruisers and nakedbikes.
and gives your motorbike the individual Drag Star character
High-strength tubular aluminium handlebar
28.6 mm in the clamping area and 22 mm outside
Alignment for easy alignment with the handlebar clamp
With holes in the handlebar for individual internal routing of the cables from the handlebar fittings.
Dimensions:
- Width: 825 mm
- Offset to the rear: 100 mm
- Outside diameter in the area of the clamp: 28.6 mm
- Outside diameter in the area of the grips: 22.2 mm
- Inner diameter: approx. 12 mm
- Width approx. at mounting: 220mm
The holes on the outside and in the middle of the handlebar are for individual routing of the armature wiring. Please note, most fittings have a locking pin in the switch unit, a hole is not present in the handlebar, this must still be drilled yourself, we have 4mm and 5mm handlebar drilling templates if required in the offer.
Our handlebars are delivered with a German ABE (General Operating Permit), there is no need for registration in the vehicle documents. If your vehicle is not listed in the ABE, you can have the handlebars approved by your responsible TÜV test centre in accordance with §19.2 StVZO and have them entered in the vehicle documents.
Scope of delivery:
1 x Raximo handlebar "flat Drag Bar".
1 x General type approval
