Raximo handlebar "Flat Drag Bar" TÜV approved
for Model: Kawasaki EN 450 A LTD EN450A 1985-1989
The extra flat Drag Bar handlebar from Raximo is perfect for conversions for choppers, cruisers and nakedbikes.
and gives your motorbike the individual Drag Star character
High-strength tubular aluminium handlebar
22,2 mm in the clamping area and 22,2 mm outside
Alignment for easy alignment at the clamp of the handlebars
With holes in the handlebar for individual internal routing of the cables from the handlebar fittings.
Dimensions:
- Width: 800 mm
- Offset to the rear: 96 mm
- Outer diameter in the area of the clamp: 22.2 mm
- Outside diameter in the area of the grips: 22.2 mm
- Inner diameter: approx. 12 mm
- Width approx. at mounting: 210mm
The holes on the outside and in the middle of the handlebar are for individual routing of the armature wiring.
Please note, most fittings have a locking pin in the switch unit, a hole is not present in the handlebar, this must be drilled yourself, we have 4mm and 5mm handlebar drilling templates if required in the offer.
Our handlebars are delivered with a German ABE (General Operating Permit), an entry in the vehicle documents is not necessary. If your vehicle is not listed in the ABE, you can have the handlebars approved by your responsible TÜV test centre in accordance with §19.2 StVZO and have them entered in the vehicle documents.
Scope of delivery:
1 x Raximo handlebar "flat Drag Bar".
1 x General type approval
